[. . . ] All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. This warranty is extended only to the original purchaser of the U-Line product. The Registration Card included with the product should be promptly completed by you and mailed back to U-Line. The following are excluded from this limited warranty: installation charges; damages caused by disasters or acts of God, such as fire, floods, wind and lightening; damages incurred or resulting from shipping, improper installation, unauthorized modification, or misuse/abuse of the product; customer education calls; food loss/spoilage; door and water level adjustments (except during the first 90 days from the date of purchase); defrosting the product; adjusting the controls; door reversal; or cleaning the condenser. [. . . ] Using two wrenches, tighten the compression fitting on the supply line (see Figure 3). Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 4). Avoid kinking the water supply line. WATER CONNECTION UL134 UL103 Figure 3 Figure 4 8 3. For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 5). Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin (see Figure 14). Be sure that the bosses on the closers align with holes in hinge and hinge plate. Tilt top of door into position in top hinge and install top hinge screw pin. Install plastic screw plugs removed in Step 2 in existing hinge holes (3 each, top and bottom). BOSS 8. 9. CLRCO008 Figure 14 12 DOOR ADJUSTMENT Your door is aligned at the factory before shipment. Occasional re-adjustment may be necessary, especially if an Overlay Panel is installed. The following procedure will correct for up to 1/4" alignment. The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (see Figure 15). Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed. Always throw away all ice cubes made during the first two to three hours of operation. 17 User's Manual NORMAL OPERATION On units with refrigerator sections, the unit has been designed to achieve a fresh food temperature of approximately 38°F. Those units with a freezer section are designed to have a freezer temperature of approximately 0°F. On units with ice makers, when the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the cube supply. Frost free icemaker units have lower ice production than manual defrost units. Ice production may be interrupted by raising the bin arm into an upright and locked position (the unit will maintain temperature for ice storage, see Figure 22). UL002A Figure 22 Certain sounds are normal during the unit's operation. You may hear the compressor or fan motor, the water valve, sounds of defrost, or ice dropping into the ice bucket. !WARNING NEVER use an ice pick, knife, or other sharp instrument to separate cubes. The ice bucket MUST be fully inserted to avoid freezing products in the refrigerator section of the Combo 2075FF. During periods of limited usage or high ambient temperatures, it is common for cubes to fuse together. If ice maker is not used regularly, the ice bucket should be emptied periodically to ensure fresh cubes. [. . . ] 2. BOSS Grasp shelf in center, lift slightly, and tilt 15°-20°. Tilt shelf at a 15°-20° angle and slide onto bosses at the desired location. UL303 2. Figure 30 25 User's Manual CRISPER !If it is pulled out too far, it could come out all the way and possibly cause damage or injury. Grasp the crisper handle and pull out to access the contents (see Figure 31). [. . . ]